Application Directions
The correct application will help extend the
life of your Vinyl Decals.
APPLICATION STEPS:
-
Make sure your surface area is clean and dry
-
Place your decal with transfer tape onto your surface, as you would like it to appear.
-
Press with your fingers, a craft stick or scraper along the transfer tape onto the surface, starting in the center and moving outward.
-
Peel the transfer tape away from the vinyl at a 45-degree angle. If the vinyl sticks to the transfer tape, simply rub the vinyl onto the surface again.
-
Continue until the vinyl decal is no longer sticking to the transfer tape.
It’s not recommended that decals on tumblers or glasses are cleaned in the dishwasher. The decal may peel off over time.
VINYL STICKERS
PRE-APPLICATION:
Prewashing the item also ensures any shrinking that may occur happens before application. >> NOTE <<
The paper backing is just to protect your decal during shipping
APPLICATION STEPS:
-
Set your iron to the Cotton/Linen setting. Make sure the steam setting is OFF (for steam irons).
-
Preheat your material for 10-15 seconds.
-
Place your iron-on, then apply medium pressure with the iron for 30 seconds.
-
Flip the material over and apply medium pressure again to the back of the material for 30 seconds.
-
Peel off plastic lining while warm.
DO NOT over iron your decal.
This can cause it to peel off later
IRON-ON DECALS
PRE-APPLICATION:
Make sure your project surface is clean
and dry.
APPLICATION STEPS:
1. Gently peel one of the outlet
decals from the sheet
2. Place it on your outlet as shown
in the example.
>> Do not use any metal tweezers or
other tools to apply.
3. Press down until fully applied.
-- These are removable --
OUTLET DECALS
APPLICATION STEPS:
-
Paint your nails with your desired color & let dry
-
Peel one of the decals from the sheet and apply it directly to your nail
-
Paint a top coat over your nails and decal & let dry
NAIL DECAL
